The CT14 is a 6U CompactPCI transition module for use in combination with MEN's D602 single-board computer.
It is plugged onto the CompactPCI backplane system slot from the rear side and leads the rear-panel serial I/O signals to standard connectors.
The signals are one RS232 UART, various signals from the two PMC slots (standard rear I/O from PMC1, AFDX from PMC2), the necessary signals for inter-board communication when connecting a second D602 (BMCX, DEX (6x UART), ACTIVE_THIS/OTHER) and various debug signals (/COM_FAIL, DI_PSU_STATUS, N_TEST and the AUX_IO signals).
It also offers a reset button, a boot switch, five LEDs for the N_TEST signals from the D602's NorthFPGA and five rotary switches allowing the /COM_FAIL, DIT_XTRL, DIT_SW_OVER, DIT_WDCTRL and DI_PSU_STATUS signals to be pulled low with an option to connect /COM_FAIL to +3.3V.
The board is designed for an operating temperature from -40 to +85°C with qualified components.
6U / 80 mm standard format
1 RS232 interface
DEX (6x UART)
-40 to +85°C qualified
RS232 UART interface
9-pin D-Sub connector
Inter-board connection to other D602
DEX (6x UART) signals
All via 44-pin HD-Sub connector
Rear I/O signals from PMC1
Via 64-pin connector
AFDX signals from PMC2
2 RJ45 connectors
All via 24-pin connector
5 rotary switches the following allowing signals to be pulled low:
/COM_FAIL (connection to +3.3V possible)
Flip switch to choose between boot images
N_TEST signal LEDs
5 LEDs on PCB
Dimensions: 233,35x80 mm conforming to CompactPCI specification for 6U boards